To restore and space of drywall that has been broken you will have sheet rock, a utility knife, quick dry-low mud joint compound, mesh tape for drywall, one inch galvanized drywall screws, a drill, drywall knife and a drywall sanding block. (It isn’t essential to bolster the horizontal edges of the replacement drywall.) Safe the 2x4s to the drywall with drywall screws (picture 4). Set the new drywall into the opening and secure to the 2x4s with screws. In this step we’re using a light-weight spackling that goes on pink and turns white when it is dry, which helps you to know it is ready for sanding.

Let it dry, then apply more drywall compound, feathering the perimeters as you go. Like we did for the patches we discussed earlier, it would take a number of coats, in addition to a light-weight sanding, between each coat. Use a razor knife to neatly minimize the tape simply beyond the sides of the “bad area”, and take away failed tape from wall.

To fix a hole in your wall typically requires some kind of patch to cover the outlet, whether or not it is a steel patch like the one I am holding right here, or another piece of drywall like this. Trim the rough edges of drywall around the patch. Tape over the joints and apply joint compound as described in the steps above (image 4).

First, twist a utility knife into the wall to carve away the joint compound from above a popped nail or screw. There you might have it. That’s easy methods to make an unsightly gap in your wall disappear earlier than your very eyes. Examine your blueprints to ensure there aren’t any electrical wires working behind the area being minimize.

Be careful that the screws do not break the paper floor of the drywall. Sand it smooth and apply a second coat if obligatory. You will also learn how to prepare the outlet and the encircling floor to help get the perfect outcomes. After it dries, sand flippantly, wipe away mud and repaint the whole space.