I do not care what your drywall water damage really is, the first thing that had been going to want to do is to find out where the water damage is definitely coming from. Let it dry, then apply extra drywall compound, feathering the perimeters as you go. Like we did for the patches we discussed earlier, it’ll take a number of coats, as well as a light-weight sanding, between each coat. Use a razor knife to neatly cut the tape simply beyond the edges of the “unhealthy area”, and remove failed tape from wall.
Drywall injury can vary from small cracks to massive holes, but most repairs are easy and cheap to repair. Next, use a large (8- to 12-inch) joint-compound taping knife to fully cowl the patch with a third and last coat. Paper tape can be utilized as properly, but it is not self adhesive and dust must be utilized to the wall first, urgent the paper tape into the mud.
(It is not obligatory to reinforce the horizontal edges of the alternative drywall.) Secure the 2x4s to the drywall with drywall screws (picture 4). Set the new drywall into the opening and secure to the 2x4s with screws. On this step we’re utilizing a light-weight spackling that goes on pink and turns white when it is dry, which lets you know it’s prepared for sanding.
If the bead is dented, use a metal-chopping hack saw to chop by the bead above and below the broken space (image 1). Then use a utility knife to cut vertically around the nook bead (picture 2). Nook bead is often hooked up with drywall nails, so use a pry bar or claw hammer to take away the fasteners.
After marrying the brand new and old studs, measure the outlet and minimize a corresponding piece of drywall. If there’s a very small separation of the tape from the wall, put a small quantity of caulk or white glue behind the tape and press it again in place. Apply mud compound and press in new piece of tape directly into the outdated track.