First, the very best methodology to repair your present nail pops is to make sure that the top of the nail or screw is recessed about 1/32 inch. Sand area and repeat steps 18 and 19 until the patch is undetectable. Spread drywall compound over the patch, feathering out the sides. Always use paper tape as mesh often cracks. When you’ve got a number of giant repairs to do and you’ll be shopping for a sheet or two of drywall, be advised that a sheet of regular half of-in.

Place a taping knife or skinny plywood behind the tool to forestall additional damage to the wall — be especially cautious to not lever against unsupported drywall or the tool will punch a hole that can require a more intensive restore. Drywall knife to apply drywall compound over the mesh.

Watch out that the screws don’t break the paper floor of the drywall. Sand it clean and apply a second coat if crucial. Additionally, you will learn to put together the hole and the encircling floor to help get the most effective outcomes. After it dries, sand calmly, wipe away mud and repaint all the area.

Then there are two methods to fix nail pops: use a screwdriver or hammer to drive the nail again into the studs (picture 1), then bracket every nail head with closely spaced drywall screws (image 2); or, remove the nail and drive a screw as a substitute, together with a second screw nearby, to re-safe the drywall to the stud.

For small holes, simply use the mud and mesh method as an alternative of slicing out the drywall. Unlike plaster, drywall has a seamless paper covering that not often cracks or splits. Use a utility knife to cut vertically along the drywall, connecting the top and bottom cuts from the hacksaw on the left and proper sides.